Sanyo PLC-WTC500AL Owner's Manual download pdf (Page 55)

Setting

Pointer

You can emphasize a part of the projected image with

this function. Use the Point ed buttons to choose either

Spotlight or Pointer and press the SELECT button. Then

use the Point 7 8 buttons to select a size of the Spotlight

(Large, Middle, or Small) or a pattern of the Pointer (Arrow,

Finger, or Dot). (See page 32 for operation.)

Pointer

Remote control

The eight different remote control codes (Code 1–Code 8)

are assigned to the projector; the factory-set, initial code

(Code 1) and the other seven codes (Code 2 to Code 8).

The same code should be set on both the projector and

the remote control. For example, operating the projector in

“Code 7”, the remote control code also must be switched to

“Code 7”.

To change the code for the projector

Select a remote control code in this Setting Menu.

To change the code for the remote control

Press and hold the MENU button and a number button

(1–8) on the remote control for more than five seconds to

switch between the codes. (See page 17 for details.)

RC sensor

Select a location of the infrared remote receiver of the

remote control. See “Remote Control Operating Range”

on page 16 for details.

All ................... Activate All of the front, top and back

receivers.

Front & Top ..... Activate the front and top receivers.

Top & Back ..... Activate the top and back receivers.

Front & Back .. Activate the front and back receivers.

Front .............. Activate only the front receiver.

Top ................ Activate only the top receiver.

Back .............. Activate only the back receiver.

Use the Point ed buttons

to choose either Spotlight

or Pointer, and then use

the Point

7 8 buttons

to switch between the

options.

✔Notes:

 •Whenusingtheprojectorinthehorizontal

positionwithouthangingfromtheceiling,

itisrecommendedtodeactivatethetop

InfraredRemoteReceivertoavoidthe

effectsofthefluorescentlight.

 •WhentheStandbymodeissetto“Eco“in

theSetting(p.56),alloftheinfraredremote

receiversareactivatedregardlessofthe

RCsensorsetting.AfterturningOffandOn

theprojector,theRCsensorsettingwillbe

activated.

1 2 ... 50 51 52 53 54 55 56 57 58 59 60 ... 88 89

Comments to this Manuals

No comments

Sanyo PLC-WTC500AL Owner's Manual Page 55

Comments to this Manuals

Related products and manuals for Film projectors Sanyo PLC-WTC500AL