Sanyo PLC-WTC500AL Owner's Manual download pdf (Page 57)

Setting

Press the SELECT button at

Power management and this

dialog box appears. Use the

Point

7 8 buttons to choose

one of the three options.

Press the Point

d button to

select the timer, and then use

the Point

7 8 buttons to set

timer.

Power management

Select one of the following options:

Ready ................. When the lamp has been fully cooled

down, the POWER indicator changes to fast

blinking. In this condition, the projection

lamp can be turned on if the input signal

is reconnected or any button on the top

control or remote control is pressed.

Shut down ......... When the lamp has been fully cooled down,

the power will be turned off.

Off ..................... Power management function is off.

On start

When this function is set to “On,” the projector will be

automatically turned on just by connecting the AC power cord

to a wall outlet.

✔Note:

 •Besuretoturnofftheprojectorproperly(see“Turning

OfftheProjector”onpage25).Iftheprojectoristurned

offintheincorrectsequence,theOnstartfunctiondoes

notworkproperly.

 •

WhentheStandbymodeissetto“Eco“intheSetting,theOn

startfuncionisdisabled.(p.56)

✔Note:

 •Factorydefaultis“Ready:5min.”

Slant

This function is used to set the cooling fans’ operation to the

projector’s setting environment. Set this function properly in

accordance with the projector’s installation method. Otherwise,

the cooling fans will not work properly and that causes

malfunctions of the projector and decreases the lamp life.

Select the projector’s installation condition from the following

options:

Off .....When using the projector within the range of the upward/

downward inclination of

±70º and +110º~ +180º, -110º ~

-180º to the horizontal plane.

L1 ......When using the projector within the range of the upward/

downward inclination of +70º~+110

º to the horizontal

plane.

L2 ......When using the projector within the range of the upward/

downward inclination of -70º~ -110

º to the horizontal

plane.

L3 ......When using the projector within the range of the upward/

downward inclination of

±70º to the horizontal planeand

the ceiling function is set to “On”.

L4 ......When using the projector within the range of the upward/

downward inclination of +110º~+180

º, -110º ~ -180º to the

horizontal plane and the ceiling function is set to “Off”.

+70°

+110°

-70°

-110°

+180°

-180°

+0°

-0°

“L4” at Ceiling “Off”

“Off” at Ceiling “On”

“L3” at Ceiling “On”

“Off” at Ceiling “Off”

Slant setting

1 2 ... 52 53 54 55 56 57 58 59 60 61 62 ... 88 89

Comments to this Manuals

No comments

Sanyo PLC-WTC500AL Owner's Manual Page 57

Comments to this Manuals

Related products and manuals for Film projectors Sanyo PLC-WTC500AL