Sanyo SAP-CRV123EH User Manual download pdf (Page 30)

7-4. How to Test Run the Air Conditioner

After turning on power to the air conditioner, use the remote

controller and follow the steps below to conduct the test run.

(1) Set the remote controller in Test Run mode.

(Fig. 8a)

a) Press and hold the QUIET button.

b) Then press and hold the 1HR TIMER button.

c) At the same time, press the ACL (reset) button once.

Use a pointed object such as the tip of a pen to press

the ACL button.

• After a few seconds, “ ” appears and “oP-1” blinks in

the remote controller display area. (Fig. 8b)

d) Release the 1HR TIMER button.

e) Release the QUIET button.

(2) Start Cooling mode test run by pressing the ON/OFF

operation button of the remote controller. (Fig. 8a)

• This starts the fan producing uncooled forced air with

the 3 indicator lamps (OPERATION lamp, TIMER lamp

and QUIET lamp) on the main unit blinking. (Fig. 8c)

• After 3 minutes, the system shifts into cooling opera-

tion, and cool air will start to be felt. Cool mode test

run is unaffected by the room temperature.

(3) Press the ON/OFF operation button of the remote con-

troller again to stop the test run. (Fig. 8a)

(4) Finally press the ACL (reset) button of the remote con-

troller to release it from Test Run mode to return to nor-

mal mode. (Fig. 8a)

• “ ” and “oP-1” will disappear from the remote con-

troller display area.

After the test run is completed, be sure to press the ACL

(reset) button to return to normal mode. The air conditioner

will not operate correctly if this is not done.

IMPORTANT

Fig. 8a

Fig. 8b

Fig. 8c

1HR.

TIMER

ON/OFF

operation

ACL

(Reset)

QUIET

button

OPERATION lamp

TIMER lamp

QUIET lamp

1 2 ... 25 26 27 28 29 30 31 32 33 34 35 ... 76 77

Comments to this Manuals

No comments

Sanyo SAP-CRV123EH User Manual Page 30

Comments to this Manuals

Related products and manuals for Mobile air conditioners Sanyo SAP-CRV123EH