Sanyo PLC-WM5500 User Manual download pdf (Page 12)

Chapter 2 Setup Procedures

Setting Procedure

Setting procedures and contents differ depending on the LAN installation location.

When installing, consult your system administrator to set up the LAN appropriately.

Connect the LAN cable to the LAN connection terminal of the projector.

Network configuration

Set the Wired LAN network through the projector menu. Detailed network settings will be

made with browser. Refer to “3. Basic setting and operation” (p.17-30). First, complete the

settings described in this chapter before performing steps in “3. Basic setting and opera-

tion.”

1. Select “Network” in the Network menu, and press Point 8 or SELECT button.

2. Select "On" with the Point

ed buttons, and the press SELECT button. Then the Menu

will disappear, the “Please wait...” message will appear, and switching operation will start.

Switching will take a while and the projector’s LINK/ACT Lamp will be on or blink, and

after completing the operation, the “Please wait...” message will disappear.

Connecting to the LAN line

LAN Cable

LAN Connection Terminal

LINK Lamp (Green)

Light green when the

projector is connected to

the network correctly.

ACT Lamp (Orange)

Blink orange when the

projector is sending or

receiving the data.

1 2 ... 7 8 9 10 11 12 13 14 15 16 17 ... 59 60

No comments

Sanyo PLC-WM5500 User Manual Page 12