Sanyo PLC-WM5500 User Manual download pdf (Page 2)

Compliance

Federal Communications Commission Notice

This equipment has been tested and found to comply with the limits for a Class B digital

device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reason-

able protection against harmful interference in a residential installation. This equipment

generates, uses and can radiate radio frequency energy and, if not installed and used

in accordance with the instructions, may cause harmful interference to radio commu-

nications. However, there is no guarantee that interference will not occur in a particular

installation. If this equipment causes harmful interference to radio or television reception

which can be determined by turning the equipment off and on, the user is encouraged

to try to correct the interference by one or more of the following measures:

- Reorient or relocate the receiving antenna.

- Increase the separation between the equipment and receiver.

- Connect the equipment into an outlet on a circuit different from that to which the

receiver is connected.

- Consult the dealer or an experienced radio/TV technician for help.

Use of shielded cable is required to comply with class B limits in Subpart B of Part 15 of

FCC Rules.

Do not make any changes or modifications to the equipment unless otherwise speci-

fied in the instructions. If such changes or modifications should be made, you could be

required to stop operation of the equipment.

Model Numbers : PLC-WM5500, PLC-WM5500L

Trade Name : Sanyo

Responsible party : SANYO NORTH AMERICA CORPORATION

Address : 21605 Plummer Street, Chatsworth, California 91311

Telephone No. : (818)998-7322

1 2 3 4 5 6 7 ... 59 60

No comments

Sanyo PLC-WM5500 User Manual Page 2