Sanyo PLC-WM5500 User Manual download pdf (Page 49)

ENGLISH

3. When communication is established correctly, the word "PASSWORD:" appears on the

window. Type the login password (Network PIN code

) for the projector and then press

"Enter" key on the keyboard. If you do not set up the Network PIN code, just press "Enter"

key.

When the word "Hello" is replied, login has been succeeded.

* The password "1234" is used for the example.

4. Type the commands, refer to below table, to control the projector and then press "Enter"

key for termination. For example, type "C00" which is a command to turn on the projec-

tor, and press "Enter" key. Confirm the projector is turning on.

* Enter with ASCII 64-byte capital characters and one-byte characters.

To disconnect the communication, press "Ctrl" key and "]" key at the same time, type

"close" and then press "Enter" key on the Keyboard.

> close [return]

The table below shows the typical command lists for controlling this projector and please

consult your local dealer for further information of another commands.

*1 Further instructions about the telnet application, please see the on-line guide on your computer.

*2 The password is a Network PIN code decided item "Network PIN code setting" (

+pp.14, 23). If the

authentication of the entered password is failed 4 times continuously, the communication will be

disconnected automatically. Please try again for the connection.

✐ If the password or any command is not entered for more than 30 seconds, the communication will

be disconnected automatically. Please try again for the connection.

Command Function

C00 Power on

C02 Power off

C09 Volume up

C0A Volume down

C0B Audio Mute on

C0C Audio Mute off

C1C Menu display on

C1D Menu display off

Command list table

Use of telnet

1 2 ... 44 45 46 47 48 49 50 51 52 53 54 ... 59 60

No comments

Sanyo PLC-WM5500 User Manual Page 49