Sanyo DSR-C100 User Manual download pdf (Page 12)

INSTALLING AND HANDLING

THE Ni-Cd BACKUP BATTERY

The Ni-Cd battery which is supplied with the camera is used as a backup power supply for the clock and the

hard disk.

The battery has not been charged. Before turning on the camera power, install the battery by referring to the

points below. If any problems with battery operation or leakages of battery fluid occur, contact the place of

purchase.

Note:

•

Once the camera’s power has been turned on

and left on for 24 hours, the battery will be

charged sufficiently to provide 30 days of

backup operation.

•

If the battery is used continuously for long

periods, leakage of battery fluid may occur. The

interior of the battery compartment is lined with

absorbent material to absorb any fluid which

should happen to leak from the battery, so if

replacing the battery after a leak has occurred,

be sure to replace this absorbent material also.

•

Always be sure to use the accessory AC

adapter. If you use some other

commercially-available AC adapter, detection of

problems with the backup battery will not be

possible, and damage to the hard disk may

result.

•

If the camera power supply is turned off or a

power outage occurs after the battery has only

been charging for a short time, it may cause the

clock setting to be re-initialized. If this happens,

the camera will not operate.

•

Never open the rear cover while power is being

supplied to the camera. Always be sure to set

the hard disk to the standby condition before

opening the rear cover. (See page 18)

(Warning displays)

•

When the camera power is turned on after the

battery has been replaced, “LOW BATT” will

appear on the monitor screen, and charging of

the battery will start automatically.

•

Approximately 1 hour of charging time is

needed before the “LOW BATT” display

disappears from the monitor screen. If the

“LOW BATT” display does not disappear after

one hour or more has passed, it may indicate a

problem with the battery.

•

If “LOW BATT” appears on the monitor screen

while the camera is in use, the warning

indicator will flash and recording of images will

be halted. This may also indicate a problem with

the battery, so replace the battery at such times.

•

If the battery has not been installed, or if the

battery terminal contacts are not complete,

“NO BATT” will appear on the monitor display.

If this happens, check the battery once more.

L42A4/US (DSR-C100) GB 2001, 4, 16

English 11

1 2 ... 7 8 9 10 11 12 13 14 15 16 17 ... 44 45

Comments to this Manuals

No comments

Sanyo DSR-C100 User Manual Page 12

Comments to this Manuals

Related products and manuals for Security cameras Sanyo DSR-C100