Sanyo KS3082 User Manual download pdf (Page 16)

How to install the air clean filter

The air clean filter needs to be installed behind the anti-mold filter.

1. Open the front panel and remove the anti-mold filter.

2. Remove the air filter holder from the anti-mold filter.

3. Install the air clean filter in the air filter holder.

4. Install the air filter holder to the anti-mold filter, remount the anti-

mold filter, and close the front panel.

How to clean the air clean filter

• In general, the filter should be sucked to remove dust in low fan

speed of a vacuum cleaner once every three months.

• If there is heavily grime on the filter, soak the filter in lukewarm

water with neutral detergent diluted 1:500 for 1 to 2 minutes then

wash it.

• Rinse the filter in clean water, then let it dry on the towel in room

temperature.

• Do not bend nor give excessive force onto the air clean filter.

• If the filter surface is heavily blocked with dirt or damaged, replace

it with new one. Purchase a replacement filter at your local dealer.

(model STK-FDXB)

Cleaning the main unit and remote control unit

• Wipe clean using a soft, dry cloth.

• To remove stubborn dirt, moisten a cloth in warm water no hotter

than 104 °F, wring thoroughly, and then wipe.

• The front panel can be removed in order to wash it with water.

Removing and remounting the front panel

Removing

Open the front panel until it is nearly horizontal, grasp the sections

near the front panel arms on both sides, and then remove the panel

by pushing the arms towards the outside while pulling the panel

towards you.

If the front panel is difficult to remove, grasp both ends of it and lift it

up slightly.

Move it to the left and disengage the left arm, then move it to the

right and disengage the right arm.

Remounting

Grasp the sections near the front panel arms on both sides, and

hold the front panel so that it is nearly horizontal. Push the arm

shafts towards the outside so that they come into contact with the

top of the indentations on the right and left sides of the air

conditioner. Then push firmly until the arm shafts click into place.

After closing the front panel, press firmly on the parts indicated by

the arrows to securely fasten the panel in place.

Also refer to the figure that shows “How to replace the anti-mold

filter”.

Washing the front panel with water

• Clean the front panel gently using a soft sponge, or the like. Then

wipe away any remaining moisture.

• Neutral detergent may be used to remove stubborn dirt. Then rinse

thoroughly with water and wipe away any remaining moisture.

This air clean filter cannot remove

harmful gases or vapors nor ventilate

air in the room. You must open doors

or windows frequently when you use

gas or oil heating appliances.

Otherwise there is a risk of suffocation

in extreme cases.

Air filter holder

Anti-mold filter

Air clean filter

NOTE

Front panel Arm

When using a footstool or the like, be

careful not to let it tip over.

CAUTION

OI-150-16-EG

01_KS3682_EN.fm Page 16 Friday, February 12, 2010 12:26 PM

1 2 ... 11 12 13 14 15 16 17 18 19 20 21 ... 35 36

Comments to this Manuals

No comments

Sanyo KS3082 User Manual Page 16

Comments to this Manuals

Related products and manuals for Split-system air conditioners Sanyo KS3082