Sanyo SANUPS E11A102A User Manual download pdf (Page 42)

−

15.4 Specifications

Item Standard or Performance Notes

Output capacity 1kVA/0.7kW

Cooling system Forced air cooling

Phases Single phase, 2-wire

Voltage

100,110,115,120V

-20% to +15% Double Conversion mode operation

5% Economy /Active Filter mode operation

10% Economy mode setting

User settable

(Rated voltage same as output voltage)

Frequency 50Hz or 60Hz

8%: Double Conversion mode operation

1, 3, 5%: Economy /Active Filter mode

operation

Power requirements 0.9kVA Max. capacity during battery charging

AC input

Input power factor 0.95 or more During rated output (*2)

Phases Single phase, 2-wire

Voltage 100, 110, 115, 120V User settable

Voltage regulation

Rated voltage

Rated frequency 50Hz or 60Hz

Same as input frequency

(auto selection)

Frequency regulation

Rated frequency

1%: Double Conversion mode Setting

Rated frequency

1, 3, 5%: Economy/Active Filter

mode operation

1, 3, 5% selectable

Internal oscillator accuracy

0.5%

Voltage waveform Sine wave

Distortion factor of

voltage waveform

Linear load: 3% or less

100% rectifier load: 7% or less

During rated output

Rapid load

change

⇔

100% at transient or output

switch

Power outage,

recovery

Rated voltage

5 %

During rated output

Transient

voltage

variation

Rapid input

voltage change

10% variation

Response time 5 cycles or less

Load power factor (lag) 0.7 (lag) Variation range 0.7 (lag) to 1.0

Overcurrent protection Auto switch to bypass circuit at 105% or more With auto return function

Inverter 105% 200ms

200% 30 seconds

AC Output

Overload

capability

Bypass

800% 2 cycles

Type Small sealed lead battery

Rated capacity

10 A

･

h (equivalent)

20 hour ratio

Number 2 (12V per battery) 2 in direct series

Batteries

Backup time

5 minutes (700W) 10 minutes (500W)

At 25°C (77°F) ambient temperature,

rated load

Generated heat 50W

Input leakage current 3mA or less

Operating environment

Ambient temperature: 0 to 40°C (32 to 104°F)

Relative humidity: 20 to 90%

(*3)

Acoustic noise 40 dB or less

1 m (approx. 40 inches) from UPS front

panel, 'A' characteristics (linear load)

(*1): The inverter is capable of operation synchronized with AC input and instantaneous

switchover provided that the AC input frequency is within

3% (or 1%, 3%, 5%,

selectable) of the rated frequency, and the AC input voltage is within +15% to-20% of the

rated voltage.

The UPS enters battery operation with the AC input frequency is outside the specified

range.

(*2): When input voltage waveform distortion is under 1%.

(*3): The UPS contains batteries. Battery service life will be foreshortened if the UPS is used

in an environment where the ambient temperature exceeds 30°C (86°F).

(*4): If grounded, the ground phase of the input and output must match according to UPS

specifications.

(*5): The above table lists standard specifications. Some specifications are different for units

with long backup times. For details, refer to the external battery specification

instruction manual.

1 2 ... 37 38 39 40 41 42 43 44 45 46

Comments to this Manuals

No comments

Sanyo SANUPS E11A102A User Manual Page 42

Comments to this Manuals