Sanyo SANUPS E11A102A User Manual download pdf (Page 45)

−

LED blinking for setting up menu

For the following two Menu Item,

•

“Restart time (battery charge rate)” in the E11A Instruction Manual §10.1 “Setup

Menu Item List No.

⑦

”.

•

“Low battery voltage signal timing” in the E11A Instruction Manual §10.1 “Setup

Menu Item List No.

⑫

”.

when confirming two items using control panel of UPS, the positions of the LED blinking for

setting up menu might be different from description in the E11A Instruction Manual.

Refer to §10.2 “Setup Menu Operations” in the Instruction Manual of E11A to confirm the

Menu Item.

These might be blinking as follows.

“Restart time (battery charge rate)” setting

“Low battery voltage signal timing” setting

When using “SANUPS SOFTWARE STANDALONE”, menu item setting of “SANUPS

SOFTWARE STANDALONE” has priority over UPS setting. Therefore above condition might

occur.

When setting change is required, configure the menu item using “SANUPS SOFTWARE

STANDALONE”.

●：

LED blinks

○：

LED off

1 2 ... 40 41 42 43 44 45 46

No comments

Sanyo SANUPS E11A102A User Manual Page 45