Sanyo PLC-XU4000 Owner's Manual download pdf (Page 54)

Remote control

This function allows you to change brightness of the screen.

Lamp control

Remote control

Lamp life control

This projector provides two different remote control codes:

the factory-set initial code (Code 1) and the secondary code

(Code 2). This switching function prevents remote control

interference when operating several projectors or video

equipment at the same time.

When operating the projector in "Code 2", both the projector

and the remote control must be switched to "Code 2".

To change the code for the projector:

Select either "Code 1" or "Code 2" in this Setting Menu.

To change the code for the remote control:

Press and hold both the MENU and IMAGE buttons

together for 5 seconds or more. After changing the code,

make sure the remote control operates properly.

Lamp control

Select the lamp operation when the total lighting time of a

lamp exceeds the recommended total hours of use.

Mode 1 .............. The lamp can be turned on even after

exceeding the recommended total

hours of use.

Mode 2 .............. The lamp can be turned on even after

exceeding the recommended total

hours of use. But the projector turns off

automatically after 3 minutes.

Lamp life control

 Note:

•Whendifferentcodesaresetontheprojectorandontheremotecontrol,anyoperationcannotbemade.In

that case, switch the code on the remote control to fit the code on the projector.

•Ifthebatteriesareremovedfromtheremotecontrolforalongperiodoftime,theremotecontrolcodewillbereset.

 Note:

•Lamp mode cannot be changed for a while after turning

on the projector. Lamp needs some time to stabilize

after the power is turned on. Stored lamp mode will be

active after the lamp is stabilized.

•IfMode 2 has been selected and the projection lamp

exceeds the recommended total hours of use, the

replacement icon will be displayed at the time of power-

on. Then the projector will turn off after 3 minutes.

 •TheLampreplacementiconwillnotappearwhenthe

Display function is set to Off (p.48), during Freeze

(p.25) or No show (p.26).

Lamp replacement icon

Setting

Auto .......... Brightness according to the input signal.

Normal ...... Normal brightness

Eco 1 ......... 70%-80% of the normal brightness.

Eco 2 ......... 50% of the normal brightness.

1 2 ... 49 50 51 52 53 54 55 56 57 58 59 ... 77 78

Comments to this Manuals

No comments

Sanyo PLC-XU4000 Owner's Manual Page 54

Comments to this Manuals