Sanyo PLC-XU4000 Owner's Manual download pdf (Page 9)

Part Names and Functions

Rear Terminal

⑤ S-VIDEO IN

Connect the S-VIDEO output signal from video

equipment to this jack (p.15).

⑦ AUDIO IN

Connect the audio output signal from video

equipment connected to ⑤ or ⑧ to this jack.

For a mono audio signal (a single audio jack),

connect it to the L (MONO) jack (p.15).

⑨ COMPUTER AUDIO IN 1

Connect the audio output (stereo) from a

computer or video equipment connected to ② to

this jack. (pp14, 16).

⑧ VIDEO IN

Connect the composite video output signal to

this jack (p.15).

② COMPUTER IN 1 / COMPONENT IN

Connect output signal from a computer, RGB scart

21-pin video output or component video output to

this terminal(pp.14,16).

④ AUDIO OUT (VARIABLE)

Connect an external audio amplifier to this jack

(pp.14-16).

This terminal outputs sound from AUDIO IN terminal

(⑦ or ⑨).

① LAN Connection Terminal

Connect the LAN cable (refer to the owner’s manual

of "Network Set-up and Operation").

②

③ ①④

⑤

⑩

⑥

⑧

⑥ CONTROL PORT

When controlling the projector with RS-232 C,

connect the control equipment to this connector

with the serial control cable.

③ COMPUTER IN 2 / MONITOR OUT

– Connect computer output to this terminal (p.14).

– This terminal can be used to output the incoming

analog RGB and Component signal from

COMPUTER IN 1/COMPONENT IN terminal to the

other monitor (pp.14,16).

⑦

⑨

⑩ COMPUTER AUDIO IN 2 (MIC IN)

Connect the audio output (stereo) from a

computer or video equipment connected to ③ to

this jack. Or connect the MIC to the this jack

(pp14, 16).

1 2 3 4 5 6 7 8 9 10 11 12 13 14 ... 77 78

Comments to this Manuals

No comments

Sanyo PLC-XU4000 Owner's Manual Page 9

Comments to this Manuals