Sanyo SANUPS E11A102A User Manual download pdf (Page 20)

−

BATT

EXT.

MAIN SW

③

Connect the input power plugs of the load devices to the output terminals.

Output terminal capacity

Note

125V 15A

terminal

If you must make a single-wire

grounded connection, always

connect the ground phase to the

V terminal (phase) side.

Note

The total output from all output terminals must not exceed 10A.

7.2 External Interface Connections

Connect a computer or option card as required.

For details, see §5.3 “External Interfaces” and §10 “User Settings”.

Note

The CARD I/F and PC I/F connectors cannot be used at the same time.

7.2.1 Connections to the PC Interface (PC I/F)

Connect a computer to the PC I/F connector to control the UPS by using the supplied power

management software.

Install the power management software on the computer, and connect the computer to the

UPS with the supplied network cable. For more information, refer to the Install Guide or User

Guide in the CD-ROM of the power management software.

Before making the connection, check that item

⑤

“PC Interface mode” in §10.1 “Setup Menu

Item List” is set as follows.

Interface mode: Workstation mode

7.2.2 Connections to the Card Interface (CARD I/F)

Connected an optional LAN interface card.

Before making the connection, check that item

⑤

“PC Interface mode” in §10.1 “Setup Menu

Item List” is set as follows

Interface mode: Workstation mode

Note

This connector is for use with Sanyo option cards only. Contact your supplier for more

information about option cards.

Terminal rated capacity

C125V 15A

The total load connected to the 6 output

terminals must not exceed 10A.

1 2 ... 15 16 17 18 19 20 21 22 23 24 25 ... 45 46

Comments to this Manuals

No comments

Sanyo SANUPS E11A102A User Manual Page 20

Comments to this Manuals