Sanyo VA-SW8000 User Manual download pdf (Page 6)

5 English

Network Connection Requirements

Before using the DVR Utility Software, configure the DVRs and computers for network connectivity

as instructed in the following sections.

● Configuring the DVRs

Configure NETWORK SET by following the

instructions for IP address configuration given

in the DVR’s documentation.

• Auto configuration

Set [ADDRESS SET] to “AUTO”.

• Manual configuration

Set [ADDRESS SET] to “MANUAL”, and

configure the IP address and subnet mask.

● Configuring the Computers

Configure the TCP/IP settings by following the

relevant instructions given in the operating

system documentation. For more information,

see P6.

Examples of configured IP address

ranges:

(These examples assume that IP address

settings are configured in Auto configuration

mode with the subnet mask set to the default

of “255.255.252.0”.)

< NETWORK SET - ADVANCED >

ADDRESS SET : AUTO

DVR NAME : DVR1

IP ADDRESS : 192.168. 0. 1

SUB NET MASK : 255.255.255. 0

DVRs:

192.168.0.1-250

192.168.1.1-250

192.168.2.1-250

192.168.3.1-250

Computers:

192.168.0.251-254

192.168.1.251-254

192.168.2.251-254

192.168.3.251-254

• All the DVRs and computers must

have their IP addresses configured in

the same segment.

• Check with the network administrator

to make sure that the IP addresses

that you want to use do not conflict

with IP addresses that are already in

use by the network.

• If you connect a LAN cable or change

the TCP/IP settings while the DVR

Utility Software is running, a

communication error may result. Be

sure to quit the DVR Utility Software

before making any change to the

physical cable connection or the

TCP/IP settings.

1 2 3 4 5 6 7 8 9 10 11 ... 131 132

Comments to this Manuals

No comments

Sanyo VA-SW8000 User Manual Page 6

Comments to this Manuals

Related products and manuals for Car DVR Sanyo VA-SW8000