Sanyo PLC-EF60A Owner's Manual download pdf (Page 16)

Preparation

This wireless remote control uses radio frequency signal. You can switch four frequency channels prepared and select a

remote control ID from eight IDs. The Remote Control Channel selection prevents radio frequency interference from the

other equipment and the Remote Control ID selection allows you to operate several projectors with their respective remote

controls without mutual interference among those projectors.

Wired Remote Control Transmitter

The remote control can be used as a wired remote control. When

interference between the projector and other equipment occurs or

the projector is used in a place where the operation of radio

equipment is restricted, connecting the remote control and the

projector with the wired remote cable (POA-CA-RC30) separatery

supplied is recommended. (p.73) Connected with the wired

remote cable, the remote control does not emit radio signal.

Remote Control Channel and ID Setup

Initial Remote Control Channel and ID are CH1 and ID1. When you

change the setting, set a Channel first, and then an ID.

Channel and ID settings for the remote control should be the

same as those for the projector. When changing the CH and ID

settings to the remote control, do it to the projector as well. Refer

to “Remote Control” in Setting menu on page 51.

Should you be lost at which CH and ID are currently set, initialize

the Channel and ID once, and set them again.

Hold down the CH button and press the SELECT button.

The Remote Control Channel switches sequentially for one

pressing the SELECT button. (See Table 1 on next page.)

Press and hold the CH and ID buttons, and slide the

REMOTE RESET/ON/ALL-OFF switch to REMOTE RESET,

and then to ON. The initial Channel and ID are CH1 and ID1.

(p.15)

CANCEL

INFO

AUTO PC

SCREEN

FREEZE

P-TIMERSOUND

REMOTE

VOL.

MUTE

INPUT 4

INPUT 1

INPUT 2

INPUT 3INPUT 5

REMOTE RESET ON ALL OFF

LENS SHIFT

KEYSTONE

SHUTTER D.ZOOM

ZOOM FOCUS

ON-OFF

While pressing the CH/ID

button, press the SELECT

button number of times

corresponding to the remote

control CH/ID.

CANCEL

INFO

AUTO PC

SCREEN

FREEZE

P-TIMERSOUND

REMOTE

VOL.

MUTE

LENS SHIFT

KEYSTONE

SHUTTER D.ZOOM

ZOOM FOCUS

ON-OFF

ID button

CH button

SELECT button

✔Note:

Remote Control Channel and ID cannot be initialized separately.

Set the Remote Control Channel

Set the Remote Control ID

Hold down the ID button and press the SELECT button. The

Remote Control ID switches sequentially for one pressing

the SELECT button. (See Table 2 on next page.)

Initialize the Remote Control Channel and ID

Remote Control Transmitter

1 2 ... 11 12 13 14 15 16 17 18 19 20 21 ... 81 82

Comments to this Manuals

No comments

Sanyo PLC-EF60A Owner's Manual Page 16

Comments to this Manuals

Related products and manuals for Data projectors Sanyo PLC-EF60A