Sanyo PLC-EF60A Owner's Manual download pdf (Page 17)

Preparation

Remote Control Battery Installation

To insure safe operation, please observe the following precautions:

● Use (2) AA or LR6 type alkaline batteries.

● Always replace the batteries in sets.

● Do not use a new battery with a used battery.

● Avoid contact with water or liquid.

● Do not expose the remote control to moisture, or heat.

● Do not drop the remote control.

● If a battery has leaked on remote control, carefully wipe case clean and install new batteries.

● Risk of explosion if battery is replaced by an incorrect type.

● Dispose of used batteries according to the instructions.

Press the lid downward

and slide it.

Open the battery

compartment lid.

Install new batteries

into the compartment.

Replace the compartment

lid.

Two AA size alkaline

batteries

For correct polarity (+ and

–), be sure battery terminals

are in contact with pins in

the compartment.

12 3

✽ Default setting

ID 7

ID 8

Remote Control ID

ID 1 ✽

ID 2

ID 3

ID 4

ID 5

ID 6

Remote Control CH

Radio Frequency

CH 1 ✽

2.472 GHz

CH 2

2.403 GHz

CH 3

2.446 GHz

CH 4

2.421GHz

Channel switches sequentially for

one pressing the SELECT button.

ID switches sequentially for one

pressing the SELECT button.

Table1: Remote Control Channel & Frequency

Table2: Remote Control ID

Preparation

Caution about Radio Wave

The remote control operates in 2.4 GHz band, the same frequency band used for industrial, scientific, and medical

equipment (such as pacemaker), as well as amateur radio stations.

Before operating the remote control, make sure no electromagnetic interference occurs and pay attention to the

following cautions.

1. Be sure that there are no other devices in the area that may use the same frequency band as the remote

control.

2. If any other devices are causing radio interferences, change the communication frequency channel or

move to other location.

Caution in Wireless LAN Interference

Under wireless LAN environment based on IEEE 802.11b and IEEE802.11g, the remote control may not operate

properly due to radio interferences. The remote control is initially set to use 2.472 GHz band (CH1) corresponding

to several channels of wireless LAN.

Should the remote control not operate properly due to radio interference, switch the communication frequency

channel to CH2. Yet the operating condition is not improved, try CH3 and CH4. In case of failure in every channel

operation, relocate other radio equipment using 2.4 GHz band away from the remote control and the projector.

1 2 ... 12 13 14 15 16 17 18 19 20 21 22 ... 81 82

Comments to this Manuals

No comments

Sanyo PLC-EF60A Owner's Manual Page 17

Comments to this Manuals

Related products and manuals for Data projectors Sanyo PLC-EF60A