Sanyo PLC-EF60A Owner's Manual download pdf (Page 63)

Maintenance and Cleaning

This projector uses a high-pressure lamp which must be handled carefully and properly. Improper handling may result

in accidents, injury, or create a fire hazard.

● Lamp lifetime may differ from lamp to lamp and according to the environment of use. There is no guarantee of the

same lifetime for each lamp. Some lamps may fail or terminate their lifetime in a shorter period of time than other

similar lamps.

● If the projector indicates that the lamp should be replaced, i.e., if the LAMP REPLACE INDICATOR lights up,

replace the lamp with a new one IMMEDIATELY after the projector has cooled down.

(Follow carefully the instructions in the LAMP REPLACEMENT section of this manual.) Continuous use of the

lamp with the LAMP REPLACE INDICATOR lighted may increase the risk of lamp explosion.

● A Lamp may explode as a result of vibration, shock or degradation as a result of hours of use as its lifetime draws

to an end. Risk of explosion may differ according to the environment or conditions in which the projector and lamp

are being used.

IF A LAMP EXPLODES, THE FOLLOWING SAFETY PRECAUTIONS SHOULD BE TAKEN.

If a lamp explodes, disconnect the projector’s AC plug from the AC outlet immediately. Contact an authorized service

station for a checkup of the unit and replacement of the lamp. Additionally, check carefully to ensure that there are

no broken shards or pieces of glass around the projector or coming out from the cooling air circulation holes. Any

broken shards found should be cleaned up carefully. No one should check the inside of the projector except those

who are authorized trained technicians and who are familiar with projector service. Inappropriate attempts to service

the unit by anyone, especially those who are not appropriately trained to do so, may result in an accident or injury

caused by pieces of broken glass.

ORDER REPLACEMENT LAMP

Replacement Lamp can be ordered through your dealer. When ordering a Projection Lamp, give the following

information to the dealer.

● Model No. of your projector : PLC-XF60A / PLC-EF60A

● Replacement Lamp Type No. : POA-LMP80

(Service Parts No. 610 315 7689)

LAMP HANDLING PRECAUTIONS

Maintenance & Cleaning

1 2 ... 58 59 60 61 62 63 64 65 66 67 68 ... 81 82

No comments

Sanyo PLC-EF60A Owner's Manual Page 63