Sanyo PLC-WTC500AL Owner's Manual download pdf (Page 16)

To ensure safe operation, please observe the following precautions :

l Use two (2) AAA or LR03 type alkaline batteries.

l Always replace batteries in sets.

l Do not use a new battery with a used battery.

l Avoid contact with water or liquid.

l Do not expose the remote control to moisture or heat.

l Do not drop the remote control.

l If the battery has leaked on the remote control, carefully wipe the case clean and install new batteries.

l Risk of an explosion if battery is replaced by an incorrect type.

l Dispose of used batteries according to the instructions.

Press the lid

downward and slide it.

Open the battery

compartment lid.

Install new batteries

into the compartment.

Replace the

compartment lid.

Two AAA size batteries

For correct polarity (+ and –),

be sure battery terminals are

in contact with pins in the

compartment.

1 2 3

Point the remote control toward the projector (to Infrared

Remote Receivers) when pressing the buttons. Maximum

operating range for the remote control is about 16.4’ (5 m)

and 60 degrees in front and rear of the projector.

Infrared Remote Receivers are provided both in front and

back of the projector. You can conveniently use both of the

receivers (see pages 10, 55).

Remote Control Receivers and Operating Range

Remote Control Battery Installation

16.4’

(5 m)

16.4’

(5 m)

Part Names and Functions

✔Notes:

 •Whenhangingtheprojectorfromtheceiling,selectthe

InfraredRemoteReceiverwhichislocatedfartheraway

fromthefluorescentlight(p.55).

 •Whenusingtheprojectorinthehorizontalposition

withouthangingfromtheceiling,itisrecommendedto

deactivatethetopInfraredRemoteReceivertoavoidthe

effectsofthefluorescentlight(p.55).

The remote control can be used as a wired remote control. Wired remote control helps you use the remote control outside

of the operating range (16.4’/ 5 m). Connect the remote control and the projector with the remote control cable (sold

separately). Connected with the remote control cable, the remote control does not emit wireless signal.

Wired Remote Control

1 2 ... 11 12 13 14 15 16 17 18 19 20 21 ... 88 89

Comments to this Manuals

No comments

Sanyo PLC-WTC500AL Owner's Manual Page 16

Comments to this Manuals

Related products and manuals for Film projectors Sanyo PLC-WTC500AL