Sanyo Welder MCO-19M(UVH) User Manual download pdf (Page 16)

INSTALLATION

1. Remove the packing tape and clean up.

Remove all the tape that is securing the doors and inner attachments. Open the doors for ventilation. If

the outer panels are dirty, dampen a cloth with a diluted neutral detergent and wipe them. (Using an

undiluted solution may damage the plastic. Follow the diluting instructions for the detergent that is used.)

Wipe off the residual detergent with a wet cloth and then wipe off any moisture.

WARNING

Do not leave plastic wrapping bags within reach of children. If a bag is placed over a child’s head, it

can block the mouth and nose and cause suffocation.

2. Adjust the leveling feet.

Adjust the leveling feet by turning them counterclockwise to level the Incubator. (See the illustration on

the right.)

3. Ground the Incubator.

Ground the Incubator during installation to prevent electric shock in case the insulation is not sufficient. If

there is no ground wire at the location, consult with qualified service personnel.

When a ground must be installed

If a grounded 3-pole outlet is not available, then a ground must be installed. Consult with qualified service

personnel.

WARNING

To prevent electric shock, always ground the Incubator. If grounding is not possible, then have a ground

installed by qualified personnel. If the Incubator is not grounded, it may result in electric shock.

Never connect the ground wire to a gas pipe, water pipe, lightning rod, or telephone ground wire.

Doing so may cause electric shock

Installing a ground fault circuit breaker

If using the Incubator in a location with moisture or humidity cannot be avoided, then it is recommended

that a ground fault circuit breaker be installed in the power supply circuit (i.e., the power supply at the

Incubator). Have the circuit breaker installed by qualified service personnel.

CAUTION

Do not climb on the Incubator or place objects on top of it. Doing so may damage it or cause it to fall

over, resulting in injury. If it is to be stacked, refer to page 72 and stack it securely.

When the Incubator is not in use

Empty the water from the humidifying pan and remove moisture from the chamber. Make sure that the

chamber is completely dry before closing the doors. Failure to do so may result in damage.

Before moving the Incubator

Before moving the Incubator, empty the water from the humidifying pan, disconnect the power supply plug

from the outlet, and make sure that the cord will not be damaged. Failure to do so may result in electric

shock or fire.

1 2 ... 11 12 13 14 15 16 17 18 19 20 21 ... 77 78

No comments

Sanyo Welder MCO-19M(UVH) User Manual Page 16