Sanyo Welder MCO-19M(UVH) User Manual download pdf (Page 19)

Connection of gas injection nozzle

In the case of control of O

density in the chamber, connect the gas injection nozzle to the gas injection

port by using the connecting pipe enclosed (inner diameter; 5 mm, outer diameter; 9 mm, length; 400

mm). This helps faster recovery of humidity after opening of the inner door.

Fill the humidifying pan with sterile distilled water so that the injection nozzle can be under the water level.

Using the inner door and gastight split doors

zTo effectively use gastight split doors, set three trays (standard equipment) at the same level as bottom

side of each gastight split door.

At the same level

as bottom side of

each gastight

split doors

Gas injection nozzle

1 2 ... 14 15 16 17 18 19 20 21 22 23 24 ... 77 78

No comments

Sanyo Welder MCO-19M(UVH) User Manual Page 19