Sanyo TLS-9024P User Manual download pdf (Page 16)

NORMAL RECORDING

Concerning the Number of Times Tapes

can be Rerecorded on

Depending on the recording speed mode, the tape must

be replaced after a certain number of recording times.

Refer to the table below for the maximum number of

times a tape can be recorded on.

Recording speed mode

(hour mode)

Maximum number of

recording times

(with a standard grade

tape)

3 100

12, 24 50

NOTES:

œ The maximum number of recording times will vary

depending on the location and kind of tape used.

Verify the recording quality and replace the tape

when the quality starts to deteriorate.

The maximum number of recording times indicated

above are based on test tapes (E-180) used by the

company.

œ If using longer tapes (i.e. E-240) the tape travel will

not be as stable and that may cause problems.

Changes to the Recording Speed Mode

During Recording

It is possible to permit or prevent changing the

recording speed mode during recording.

1 Press the MENU button until the (SET UP 4) menu

is displayed.

@@@@@@@<SET@UP@4>

öSW@OUT

@@FIELD@@@@@@@@@01

@@TIMING@@@@@@@@FIELD

@@3H@@@@@@@@@@@@Y

öTHREAD@CHECK@@@Y

öVIDEO@LOSS@@@@@N

öREC@SPEED@@@@@@N

2 Turn the JOG dial, until the “REC SPEED” setting is

flashing.

3 Turn the SHUTTLE ring, to set the desired mode.

Y. . . . . . . . . . Recording speed mode can be

changed

N. . . . . . . . . . Recording speed mode can not

be changed

4 Press the SEARCH/AUDIO ON button to save the

setting.

Action to Take when the Video Signal

Deteriorates

If there is no video signal during recording, fast forward,

rewind modes, when in stop mode or when a tape is not

loaded the menus are not displayed, “VIDEO LOSS”

can be displayed on-screen and a signal (0 V) can be

output at the ALARM OUT terminal. If in the (SET UP

2) menu, in the BUZZER section WARNING is set to

“Y”, the buzzer will be heard. To stop the buzzer, press

the STOP button.

1 Press the MENU button until the (SET UP 4) menu

is displayed.

2 Turn the JOG dial, until the “VIDEO LOSS” setting

is flashing.

3 Turn the SHUTTLE ring, to set the desired mode.

N. . . . . . . . . . The video loss warning is not

active.

Y. . . . . . . . . . The video loss warning is active.

4 Press the SEARCH/AUDIO ON button to save the

setting.

RR4Q/EX2 (TLS-9024P GB) Fri. Sept., 29/2000

English 15

1 2 ... 11 12 13 14 15 16 17 18 19 20 21 ... 38 39

Comments to this Manuals

No comments

Sanyo TLS-9024P User Manual Page 16

Comments to this Manuals

Related products and manuals for Video recorders Sanyo TLS-9024P