Sanyo PLC-EF60A Owner's Manual download pdf (Page 51)

Setting

PIN Code Change

Logo PIN code can be changed to your desired four-digit number.

Select “PIN code change” with the Point buttons (e, d, 7, and

8) or the Control pad and press the SELECT button. Set a new

Logo PIN code.

Be sure to note the new Logo PIN code and keep it at hand. If

you lost the number, you could no longer change the Logo PIN

code setting. For details on PIN code setting, refer to relevant

instructions of the PJ Lock function on page 55.

Background

Three background settings are available in this projector. Select

one of the followings when no input source is connected to the

projector or no input signal is coming from the connected

equipment:

Blue . . . . . .blue colored background

My logo . . .the image you captured

Black . . . . .black colored background

Lamp

Control

This feature allows you to change brightness of the screen.

Normal

. .normal brightness

Auto . . . .

brightness according with the input signal

Eco

. . . .lower brightness reduces the lamp power

consumption and extends the lamp life.

Mode

This projector is equipped with two lamps. Mode setting allows

you to switch using one (1) lamp or two (2) lamps.

2-Lamp . . . .light both of the lamps inside the projector.

1-Lamp . . . .light one lamp only. Auto, Lamp 1, or Lamp 2 can be

altered.

PIN Code change Dialog Box

Pointer

Select PIN code change and

press the SELECT button.

The PIN code input dialog

box will appear.

Lamp Control

✔Note:

• When neither of the two lamps is lighted, the projector will shutdown automatically.

• When either of the two lamps does not light up, the LAMP 1/2 REPLACE indicator

blinks orange and the projector will light the other automatically.

• After changing the lamp mode, it cannot be switched again for 90 seconds.

Setting

Lamp Mode

When selecting Auto in 1-Lamp

mode, the projector automatically

selects either lamp of which the

total Lamp time is shorter and

lights it up.

Remote control

Four (4) remote control channels and eight (8) remote control ID

are prepared for the projector to prevent radio frequency

interference from the other equipment and mutual interference

between projectors when using them at the same time.

For example, operating the projector in “CH-2 and ID-7,” both the

projector and the remote control must be switched to “CH-2 and

ID-7.”

To change CH and ID for the projector;

Select a Remote control CH and ID in this Setting menu.

To change CH and ID for the remote control;

While holding down the CH or ID button and press the SELECT

button. The Remote control CH or ID switches sequentially for

one pressing the SELECT button. Changing CH and ID should be

done separately. (See pages 16 and 17 for details.)

Remote control

When pressing the SELECT button at Remote control,

the remote control CH and ID menu appears. Select CH

and ID respectively.

The setting

selected.

Pointer

1 2 ... 46 47 48 49 50 51 52 53 54 55 56 ... 81 82

Comments to this Manuals

No comments

Sanyo PLC-EF60A Owner's Manual Page 51

Comments to this Manuals

Related products and manuals for Data projectors Sanyo PLC-EF60A