Sanyo Welder MCO-19M(UVH) User Manual download pdf (Page 25)

BASIC OPERATIONS ON CONTROL PANEL

The following operation are possible through control panel:

z Setting the temperature・・・The chamber temperature can be set (page 25).

z Setting the CO

density・・・The chamber CO

density can be set (page 25).

z Setting the O

density・・・The chamber O

density can be set (page 25).

Setting the key lock・・・Changing the temperature and CO

density can be disabled (page 26).

z Setting alarms・・・The temperature alarm, CO

density alarm, O

density alarm (page 33) and upper

limit alarm temperature (page 32) can be set.

z Setting UV parameters・・・ON/OFF parameters and the ON period of the UV lamp can be set for the

MCO-19M(UVH)/19M(UV) or when the Incubator is equipped with the optional MCO-19UVS (page 36).

z Setting other parameters・・・The initial settings of the date, time, and log cycle (page 38), and the

LCD display and baud rate (page 40) can be set.

z Displaying the operation log and transferring data・・・A graph of past operation data can be

displayed (page 41) and operation data can be transferred to a PC (page 43).

z H

decontamination・・・H

decontamination of the chamber and internal attachments can be

performed when the optional H

Generator (MCO-HP) is installed (page 49).

z Automatic N

(or O

) gas cylinder changeover・・・The N

(or O

) gas cylinder can be switched (page

30). The CO

gas cylinder can be switched when the optional automatic CO

Cylinder Changeover

System (MCO-21GC) is installed (page 67).

z Setting the standard gas density・・・The standard gas density can be set when the optional

Automatic Standard Gas Calibration Kit (MCO-SG) is installed. (page 69)

1 2 ... 20 21 22 23 24 25 26 27 28 29 30 ... 77 78

No comments

Sanyo Welder MCO-19M(UVH) User Manual Page 25