Sanyo CG1411 User Manual Page 95
- Page / 100
- Table of contents
- TROUBLESHOOTING
- BOOKMARKS
Rated. / 5. Based on customer reviews
Adjusting the Airflow Direction
1. Horizontal The horizontal airflow can be adjusted by moving the vertical vanes with
your hands to the left or right.
CAUTION
When the humidity is high, the vertical vanes should be in the front
position during the cooling or dehumidifying operation. If the vertical vanes
are positioned all of the way to the right or left, condensation may begin
to form around the air vent and drip down.
2. Vertical The vertical airflow can be adjusted by moving the flap with the remote
control unit. Do not move the flap with your hands. Confirm that the remote
control unit has been turned on. Use the FLAP button to set either the
sweep function or one of the six airflow direction settings.
(The maximum capacity is obtained at the position at 4.)
A. Sweep function B. Setting the airflow manually
The flap starts moving up and down to
deliver air over the sweep range.
Referring to the above illustration, use
the FLAP button to set the airflow
direction within the range used during
the heating, cooling, or dehumidifying
operation.
NOTE
•
The flap automatically closes when the unit is off.
•
During the heating operation, the fan speed will be very low and the
flap will be in the horizontal position (position 6) until the air being
blown out of the unit begins to warm. Once the air warms up, the flap
position and fan speed change to the settings specified with the remote
control.
CAUTION
•
Use the FLAP button on the remote control to adjust the position of the
flap. If you move the flap by hand, the flap position according to the
remote control and the actual flap position may no longer match. If this
should happen, shut off the unit, wait for the flap to close, and then turn
on the unit again; the flap position will now be normal again.
•
Do not have the flap pointed down during cooling operation.
Condensation may begin to form around the air vent and drip down.
COOL
and
DRY
HEAT
SWEEP
SWEEP
1
2
3
4
5
6
1HR.
TIMER
ON
OFF
TEMP.
FAN SPEED
MODEFLAP
ON OFF
SET
CANCEL
NIGHT
SETBACK
ACL
BATTERIES
23OI-202-23EG
oi202000
- GAS HEATER AIR CONDITIONER 1
- IMPORTANT! 2
- Please Read Before Starting 2
- Table of Contents 3
- 1. OPERATING RANGE 5
- 2. SPECIFICATIONS 6
- 2-2-1. Indoor Unit 8
- 2-2-2. Outdoor Unit (1) 9
- 2-2-2. Outdoor Unit (2) 10
- 2-3-1. Indoor Unit 11
- 2-3-2. Outdoor Unit 12
- 3. DIMENSIONAL DATA 13
- 3-1-2. Outdoor Unit 14
- 3-2. Internal Components 15
- 3-2-2. Outdoor Unit 16
- 3-3. Major Components 17
- (3) Main Burner 18
- Type: Ribbon Burner 18
- (4) Combustion Blower 18
- (5) Refrigerant Heater 19
- 4. REFRIGERANT FLOW DIAGRAM 20
- 5. PERFORMANCE DATA 21
- 5-3. Cooling Capacity 23
- 5-4. Heating Capacity 24
- 6. ELECTRICAL DATA 25
- (1) Indoor unit KGS1411 26
- (2) Outdoor unit CG1411 27
- 4FF4B10002710-2 28
- 7. INSTALLATION INSTRUCTIONS 29
- Min. 6" (15 cm) 30
- Valve side 30
- Min. 10" 30
- 7-3-1. Mounting on a Wall 32
- 8. FUNCTION 33
- 8-1-3. Combustion Control 34
- 8-2. Cooling 35
- 8-3. Heating 37
- 8-3-2. Refrigerant Control 38
- 8-7. Freeze Prevention 44
- 8-8-1. Indoor Unit 45
- 8-8-2. Outdoor Unit 45
- 9. OPERATION FLOWCHARTS 46
- 11. POINTS TO DIAGNOSE 54
- 11-3-1. Components 55
- 11-3-2. Indoor Unit 56
- 11-3-3. Outdoor Unit 56
- 12. TROUBLESHOOTING 57
- Start of Operation) 58
- ●● ●● ●● 63
- ●● ● ●● ●● 63
- ●● ● ●● ● 64
- ●● ● ● ●● 64
- ●● ● ● ● 64
- ● ●● ●● ●● 65
- ●● ● ● ●.” 65
- ● ●● ●● ● 66
- ● ● ●● ●● 66
- ● ● ●● ● 66
- Outdoor PCB 69
- 13-2. Refrigerant Recovery 70
- 13-5. Refrigerant Charging 71
- INSTRUCTION MANUAL 73
- KGS 1411 + CG1411 73
- APPENDIX 73
- Operating Instruction 74
- Installation Instruction 74
- Contents 75
- Product Information 75
- Alert Symbols 75
- Features 76
- Installation Location 77
- Electrical Requirements 77
- Safety Instructions 78
- OI-202-07EG 79
- IMPORTANT 80
- SET TEMP 81
- Remote Control Unit 82
- OI-202-11EG 83
- Using the Remote Control Unit 84
- Mounting the Remote 85
- Control Unit 85
- OI-202-13EG 85
- Operation with the Remote 86
- OI-202-15EG 87
- 2. Manual Operation 88
- OI-202-16EG 88
- 3. Adjusting the 89
- Fan Speed 89
- 4. Fan Only 90
- 5. Night Setback Mode 90
- OI-202-18EG 90
- OI-202-19EG 91
- Special Remarks 92
- Using the 12-Hour ON and OFF 93
- Using the 1-Hour OFF Timer 94
- OI-202-23EG 95
- OI-202-24EG 96
- OI-202-25EG 97
- Care and Cleaning (continued) 97
- Troubleshooting 99
- Tips for Energy Saving 99
- Operating Range 99
- For Parts or Service Contact 100
Related products and manuals for Heat pumps Sanyo CG1411
Heat pumps Sanyo KH2442 User Manual
(202 pages)
(202 pages)
Heat pumps Sanyo CH1822 User Manual
(17 pages)
(17 pages)
© 2020, manymanuals.com. All rights reserved. | 0.368 s |
Manymanuals.com
Manymanuals.de
Manymanuals.fr
Manymanuals.it
Manymanuals.pl
Manymanuals.cz
Manymanuals.es
Manymanuals-pt.com
Comments to this Manuals