Sanyo CG1411 User Manual download pdf (Page 31)

100

● provide a solid base (level concrete pad, concrete

block, 4 in. × 16 in. (10 × 40 cm) beams or equal),

a minimum of 4 in. (10 cm) above ground level to

reduce humidity and protect unit against possible

water damage and decreased service life (Fig. 5b).

● use lug bolts or equal to bolt down unit, reducing

vibration and noise.

● use only the type of gas indicated on the name-

plate. This plate is located on the right side of the

outdoor unit, and should be checked before gas

line connection.

Min. 4" (10 cm)

Anchor bolts

(4 pcs.)

Exhaust

guard

Exhaust

port

Screws

Fig. 5b

7-2. Recommended Wire Length and Diameter

Regulations on wiring diameter differ from locality to locality. For field wiring requirements, please refer to your

local electrical codes. Carefully observe these regulations when carrying out the installation.

Refer to the wiring system diagram (Fig. 6).

Refer to your local codes or in the absence of local codes with the National Electric Code: ANSI/NFPA70.

NOTE

INDOOR UNIT

TERMINAL (4P) TERMINAL (6P)

OUTDOOR UNIT

(INTER UNIT)

Power line

115V

Grounding line

Disconnect switch

(Field supply)

Power supply:

Single-phase 60 Hz

115 VAC

Fig. 6

CAUTION

● Be sure to connect the power supply line to the

outdoor unit as shown in the wiring diagram. The

indoor unit draws its power from the outdoor

unit.

WIRING SYSTEM DIAGRAM

WARNING

● Be sure to comply with local codes on running

wiring from the outdoor unit to the indoor unit

(size of wire and wiring method, etc.).

● Each wire must be firmly connected.

● No wire should be allowed to touch refrigerant

tubing, the compressor, or any moving part.

● To avoid the risk of electric shock, each air

conditioner unit must be grounded.

WARNING

1 2 ... 26 27 28 29 30 31 32 33 34 35 36 ... 99 100

Comments to this Manuals

No comments

Sanyo CG1411 User Manual Page 31

Comments to this Manuals

Related products and manuals for Heat pumps Sanyo CG1411